PCB Making and Design
 |
| 1. The First step is, erase the smooth surface of the PCB, after erasing, put the masking tape on the area that you erase. | . |
|
|
|
|
|
|
|
|
 |
| 2. Get a carbon paper then trace it by the use of the cutter and before you cut, put a little excess so that you can fold it in the edge of the PCB. | |
|
 |
| 3. After you fold the Carbon Paper from the edge of the PCB, use a tape(masking tape) to hold it. |
 |
| 4. Get the Photocopy of your design, put it in the top of the carbon paper and use a tape (masking tape) to hold it. |
 |
| 5. Trace your design using a pen or a sharp pencil. |
 |
| 6. Result of the PCB after tracing it. |
 |
| 7. Finish Product Using The Cutter. |
Final Step in Making The PCB Design
 |
| Soaking of PCB more or less than 30 minutes. |
Finish Product
Drilling
Finish Product
No comments:
Post a Comment